Renewable energy production and use has grown at an overwhelming rate – the acceptance and uptake of this technology has been greater than anticipated with countries continuing to set target dates for converting to 100% renewable energy .
At least 30 countries generate more than 20% of their energy from renewables, and 120 countries have policy targets for longer-term shares of renewable energies. The European Sustainable Energy Vision outlines the transition of the energy supply and demand for the 27 EU countries to 100% renewable energy by 2050  which was then revised to 2040 .
By the end of 2015, 23.7% of energy came from renewable sources: 16.6% from hydro power; 3.7% from wind; 2% from biomass; 1.2% from Photo Voltaic (PV) and 0.4% from geothermal, concentrated power and ocean .
Figures 1 and 2 show that solar PV has the highest growth rate, however recently large scale CSP has been gaining a lot of attention, and per kw, wind power has the fastest growth .
Figure 1: Average Annual Growth Rates of Renewable Energy Capacity and Biofuels Production, End-2010 to End 2015 
A number of challenges arise with the use of renewable energies. Firstly, energy is not ‘on demand’ and therefore may not always be available when required. This issue is more pertinent in terms of a source like solar, which is only available during sunlight hours. The practiced solution to this problem is simply to have a combination of different power generation sources, such as those listed in Figure 2.
An important fact to note is that with the exception of solar PV (which creates DC through the photovoltaic effect), renewable sources create power through the use of a generator which is driven by a prime mover. The prime mover can be wind, steam from
concentrating solar thermal, hydro, geothermal, ocean from currents/waves, or biomass.
Figure 2: Renewable energy indicators 
A second challenge with renewable energy is the land size required to sustain the planet’s energy needs. For a move to 100% renewable energy every step must be taken to design the smallest footprint. To do this energy systems must be designed to be as efficient as possible. The generator is no doubt a key factor in these systems and should be designed and retrofitted to meet the prime mover’s needs.
Accepted facts about the most efficient generators are:
1.They use permanent magnets which leads to
- High efficiency
- Reduced copper losses associated with energising the rotor winding
- Less heat generation
- High torque density
- Unity power factor
- Very quiet operation
2. They use Interior Permanent Magnets (IPM) allows for flux focussing, meaning
- High flux density
- High power density
- Low flux leakage
- Robust structure
- Easy heat dissipation
3. Removing electronics to obtain
- Increased efficiency
- Simpler design
- High reliability
These are all concepts well-known to Radial Flux Laboratories (RFL), however, not satisfied with this, RFL is pushing the envelope by modelling and developing new configurations tailored to improving the efficiency of generators to integrate seamlessly with the renewable energy source.
Future posts will describe RFL’s sophisticated approach and design on developing generators that integrate with wind turbines, and the development of DC generators which have many advantages including combating harmonics produced by non-linear loads.
 Renewable Energy World. (2013). 100 Percent Renewable Vision Building [Online]. Available FTP: http://www.renewableenergyworld.com/articles/2013/04/100-percent-renewable-vision-building.html?amp%253bbuffer_share=fdc06
 International Network for Sustainable Energy. (2004). EU-25 Sustainable Energy Vision 2050 [Online]. Available FTP: http://www.inforse.org/europe/VisionEU25.htm
 International Network for Sustainable Energy. (2004). EU-27 Sustainable Energy Vision 2040 [Online]. Available FTP: http://www.inforse.org/europe/VisionEU27.htm
 Global Status Repot (2016). REN21 Renewable Energy Policy Network for the 21 Century [Online]. Available FTP: http://www.ren21.net/wp-content/uploads/2016/06/GSR_2016_Full_Report.pdf
Credit: Ezra Bowen